Plasto-Joint Stik

[john.m.cole3]

I just got this secondary to @AZDesertRat recommendations. How much should I apply? Will the pipes be easy to remove once this product is applied? Thanks!

 

[john.m.cole3]

Bump for the plumbing experts

 

[mfinn]

I am certainly not a expert, but I did start using this on my threaded connections.
I just used it as I did with other similar products. Filled the threads up, without packing it in.
I had to pull one connection apart about a week after putting it together and it came apart just fine.
Added a little more and put it back together.

 

[john.m.cole3]

Ok, thank you for the response. I wasn't sure if being liberal with the application would be a good idea. Very pleased to hear disassembly was ok.

 

[cromag27]

I've been using this for years. I pack the threads full, where the nut will be. it stays pliable so no issue with removing the nut.

 

[john.m.cole3]

I've been using this for years. I pack the threads full, where the nut will be. it stays pliable so no issue with removing the nut.

so you use it on bulkheads?

 

[cromag27]

All plastic threads.

 

[john.m.cole3]

All plastic threads.

Good to know. I've always done slip fittings, but wanted to make some fittings removable for when we move and I'm hoping it saves on unions...

 

[Smo]

This stuff works wonderfully for all plastic threads. I've had zero leaks. Stays soft and pliable for years. Easy to disassemble. And you don't have to overly tighten your connections. A good snug hand tight is plenty good enough provided you have good coverage on the threads. I rub it on perpendicular to the threads to ensure the grooves are full. I will never use Teflon tape again!!!