Hello,
I recently purchased a 612x2 reactor. After experiencing a slight leak in the seat of the second chamber to the base (fixed now, thank you for the glue).
I'm now experiencing a problem with the co2 not entering the reactor unless set at a higher bubble rate. I notice when i unplug the feed pump (MJ1200 as recommeneded) the co2 build up will then release. Once plug back in, it then stops the co2. It seems to be a direct correlation between the feed pumps pressure and the co2 balancing out. In which the feed pump wins at a lower psi.
Secondary reg set at 12 psi and effluent @ 70 ml/min. Electronic doser - anything over 1 bps has a hard time pushing through.
Please advise on how to correct this. I used to run a 618, 5 years ago with great ease and success - which is why i went with another one of your products..
I recently purchased a 612x2 reactor. After experiencing a slight leak in the seat of the second chamber to the base (fixed now, thank you for the glue).
I'm now experiencing a problem with the co2 not entering the reactor unless set at a higher bubble rate. I notice when i unplug the feed pump (MJ1200 as recommeneded) the co2 build up will then release. Once plug back in, it then stops the co2. It seems to be a direct correlation between the feed pumps pressure and the co2 balancing out. In which the feed pump wins at a lower psi.
Secondary reg set at 12 psi and effluent @ 70 ml/min. Electronic doser - anything over 1 bps has a hard time pushing through.
Please advise on how to correct this. I used to run a 618, 5 years ago with great ease and success - which is why i went with another one of your products..