Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Any thoughts on humidity management ? I’m planning a similar size build and it’s a concern
Nice build. I’m out in Steiner Ranch, but office is in Lakeway. Reach out if you ever need a hand with anything.
Man, this hits close to home. Just remodeled mine and honestly it just about killed me. The lack of contractors and experience out here really makes thing hard. Dont even get me started on the cost. Don't know how my tank survived these last 6 months lol. If you're ever looking for sometime, check with me first, as I tend to hoard stuff around here.We put in an offer on a house in Lakeway on Rolling Green Drive, actually happy it didn't go through. It was a very large house and needed a complete remodel. The pool also needed to be redone, chunks of plaster were breaking off.
Man, this hits close to home. Just remodeled mine and honestly it just about killed me. The lack of contractors and experience out here really makes thing hard. Dont even get me started on the cost. Don't know how my tank survived these last 6 months lol. If you're ever looking for sometime, check with me first, as I tend to hoard stuff around here.
Looking good, what are you planning to do for the skin of the cabinets?
It’s been a long time coming for this moment! You must be stoked to get the cycle started. Can’t wait to see this beast filled up and stocked.Well, I finally finished my aquascape, have sand in the tank and I’m filling it with RODI now.
I also got 100% of the plumbing done and got most of the electrical done too.
I’ll provide more updates after the tank fills and I start cycling it.
It’s been a long time coming for this moment! You must be stoked to get the cycle started. Can’t wait to see this beast filled up and stocked.
cant Wait to hear feedback on the skimmer.
what are the initial stocking plans for fish/cuc.
it sounds like space is an issue. What are the main areas and what would you do differently?
Great build, couple questions:
1. Initially you were going with Lifegard Aquatics Pro-Max High Output UV Sterilizers but looks like you went with RK2 XFLO UV sterilizers, why the change?
2. Why did you decide to use Hayward valves?
3. I may have missed it but with the Neptune Flow sensors, did you permanent cement and then use unions OR go with thread sealant?
Thank you for info. I am debating on either the Lifegard or RK2 UV in general.
1. Where do you have your Hayward valves located?
2. Where are you in your "cycle"? ever hit the "ugly phase" with diatoms or did UV control all that along with live rock?
3. I may have missed, but what are your goals? fish only, lps, sps?
Thank you. What two model number RK2 Sterilizers did you end up choosing/installing?