I'm using my profilux for both ATO and AWC. I am using ATO with 2 sensors (float + optical) for redundancy and then I have a third float sensor below them for the lower limit of the AWC.
I've disabled the ATO pump socket during the AWC with programmable logic but this does not disable the ATO function itself, so the maximum run time is exceeded during the AWC and the alarm goes off.
Is there a way to disable the ATO function entirely during the AWC while still using 2 sensors for the ATO? I know it could be achieved with timers but for now I'm more comfortable running the AWC manually until I've installed a proper drain (rather than just a bucket).
I've disabled the ATO pump socket during the AWC with programmable logic but this does not disable the ATO function itself, so the maximum run time is exceeded during the AWC and the alarm goes off.
Is there a way to disable the ATO function entirely during the AWC while still using 2 sensors for the ATO? I know it could be achieved with timers but for now I'm more comfortable running the AWC manually until I've installed a proper drain (rather than just a bucket).