Here's my updated mp40 guard. I did not like how the ones people have already made slip over the existing cover. I wanted to make one from scratch that would both fit the wet side assembly and have a redirector built into it.
I have four mp40s on my 320 gallon tank. All four are on the back wall. The two center ones do not have a redirector. The two on the sides do.
Using:
fusion 360
Cura 5.3
creality s1 plus direct drive.
The final prints were in black PETG.
I have four mp40s on my 320 gallon tank. All four are on the back wall. The two center ones do not have a redirector. The two on the sides do.
Using:
fusion 360
Cura 5.3
creality s1 plus direct drive.
The final prints were in black PETG.