Rodi phosphates high what to do

nightmarepl

Well-Known Member
View Badges
Joined
Mar 12, 2018
Messages
807
Reaction score
285
Rating - 0%
0   0   0
So I’ve ran an rodi for water changes for 2 years now replaced the canisters few times now..
so i checked my fish tank and I’m at .88 on hanna
I checked my rodi with reef crystal mix and it’s .09 shouldn’t that be 0?
Can’t figure out how the hell to bring down my phosphates tanks started to get invaded by cyano algae basically 3 days in invasion…

trying to get my sump setup better running my skimmer basically higher skim to dump every 3 days

tried using chemiclean it cleans it up but comes back after the 2 waters changes
 

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
67,930
Reaction score
64,368
Location
Arlington, Massachusetts, United States
Rating - 0%
0   0   0
So I’ve ran an rodi for water changes for 2 years now replaced the canisters few times now..
so i checked my fish tank and I’m at .88 on hanna
I checked my rodi with reef crystal mix and it’s .09 shouldn’t that be 0?
Can’t figure out how the hell to bring down my phosphates tanks started to get invaded by cyano algae basically 3 days in invasion…

trying to get my sump setup better running my skimmer basically higher skim to dump every 3 days

tried using chemiclean it cleans it up but comes back after the 2 waters changes

I do not believe that RO/DI is the primary source, assuming your numbers are accurate.


Comparison of Food Sources of Phosphate to Other Sources
What about other sources of phosphate, like the “crappy” RO/DI water containing 0.05 ppm phosphate? A similar analysis will show it equally unimportant relative to foods.

Let’s assume that the aquarist in question adds 1% of the total tank volume each day with RO/DI to replace evaporation. Simple math shows that the 0.05 ppm in the RO/DI becomes 0.0005 ppm added each day to the phosphate concentration in the aquarium. That dilution step is critical, taking a scary number like 0.05 ppm down to an almost meaningless 0.0005 ppm daily addition. Since that 0.0005 ppm is 40-600 times lower than the amount added each day in foods (Table 4), it does not seem worthy of the angst many aquarists put on such measurements. That said, tap water could have as much as 5 ppm phosphate, and that value could then become a dominating source of phosphate and would be quite problematic. Purifying tap water is important for this and many other reasons.
 

Troylee

all about the diy!!!!!
View Badges
Joined
Jan 15, 2010
Messages
18,743
Reaction score
15,391
Location
Vegas baby!!!!
Rating - 0%
0   0   0
I do not believe that RO/DI is the primary source, assuming your numbers are accurate.


Comparison of Food Sources of Phosphate to Other Sources
What about other sources of phosphate, like the “crappy” RO/DI water containing 0.05 ppm phosphate? A similar analysis will show it equally unimportant relative to foods.

Let’s assume that the aquarist in question adds 1% of the total tank volume each day with RO/DI to replace evaporation. Simple math shows that the 0.05 ppm in the RO/DI becomes 0.0005 ppm added each day to the phosphate concentration in the aquarium. That dilution step is critical, taking a scary number like 0.05 ppm down to an almost meaningless 0.0005 ppm daily addition. Since that 0.0005 ppm is 40-600 times lower than the amount added each day in foods (Table 4), it does not seem worthy of the angst many aquarists put on such measurements. That said, tap water could have as much as 5 ppm phosphate, and that value could then become a dominating source of phosphate and would be quite problematic. Purifying tap water is important for this and many other reasons.
My tds is horrible in Vegas! 515 going into my membrane and coming out at 14… it kills di resin fast ugh… I’ve never checked a fresh batch of saltwater for po4 I’m curious now… it’s been a battle to get my po4 down and I’m finally winning since dosing neonitro to get my no3 up a little more..
 
OP
OP
nightmarepl

nightmarepl

Well-Known Member
View Badges
Joined
Mar 12, 2018
Messages
807
Reaction score
285
Rating - 0%
0   0   0
I do not believe that RO/DI is the primary source, assuming your numbers are accurate.


Comparison of Food Sources of Phosphate to Other Sources
What about other sources of phosphate, like the “crappy” RO/DI water containing 0.05 ppm phosphate? A similar analysis will show it equally unimportant relative to foods.

Let’s assume that the aquarist in question adds 1% of the total tank volume each day with RO/DI to replace evaporation. Simple math shows that the 0.05 ppm in the RO/DI becomes 0.0005 ppm added each day to the phosphate concentration in the aquarium. That dilution step is critical, taking a scary number like 0.05 ppm down to an almost meaningless 0.0005 ppm daily addition. Since that 0.0005 ppm is 40-600 times lower than the amount added each day in foods (Table 4), it does not seem worthy of the angst many aquarists put on such measurements. That said, tap water could have as much as 5 ppm phosphate, and that value could then become a dominating source of phosphate and would be quite problematic. Purifying tap water is important for this and many other reasons.
What do you think would be the best fix for this i was thinking running gfo for a few months to bring the phosphates down and introduce a good amount of chaeto to my sump start harvesting that in high volume which should over the phosphate production
 

Ingenuity against algae: Do you use DIY methods for controlling nuisance algae?

  • I have used DIY methods for controlling algae.

    Votes: 40 46.0%
  • I use commercial methods for controlling algae, but never DIY methods.

    Votes: 20 23.0%
  • I have not used commercial or DIY methods for controlling algae.

    Votes: 21 24.1%
  • Other.

    Votes: 6 6.9%
Back
Top