iReefer12
Well-Known Member
I have a brand new 2” Neptune Systems flow sensor, couldn’t fit it on my feed line to my skimmer, so had to use a 1” instead.
I already glued 1.5” reducer bushing into the Union, so it is ready to go for 1.5” plumbing. And already sealed the threads. (As most will already know, it’s 50/50 with the threads, I did 3 and 1 drip-leaked, so had to take apart and redo, and it fixed the leak, so, needless to say, the thread has been sealed, but it may or may not need redoing.)
Anyway, $90 shipped.
I already glued 1.5” reducer bushing into the Union, so it is ready to go for 1.5” plumbing. And already sealed the threads. (As most will already know, it’s 50/50 with the threads, I did 3 and 1 drip-leaked, so had to take apart and redo, and it fixed the leak, so, needless to say, the thread has been sealed, but it may or may not need redoing.)
Anyway, $90 shipped.
