New RedSea Nanomat fit in a Waterbox?

[LaReef88]

I just upload it to Thingiverse, is gonna take 24 hours to be available

will this work for 30.2 or 35.2? I need to buy one asap

 

[krayzie]

Did you have any issues with this print? Seem to not trigger the sensor to roll.

do you still have the tabs for the filter cup holder?

 

[LaReef88]

whats the dimensions of the first chambes of the 30.2

I was resarching.. looks like is the same as the 35.2 ( 3.2" × 4.7" × 17.1) for the water filter sock chamber

 

[what_the_reef]

do you still have the tabs for the filter cup

do you still have the tabs for the filter cup holder?

do you still have the tabs for the filter cup holder?

Think I found the issue my water level was a bit low and wasn’t reaching the first two sensors. Raised it a bit so it should work now!

 

[LaReef88]

will this work for 30.2 or 35.2? I need to buy one asap

do u have any available to buy?

 

[krayzie]

do u have any available to buy?

do you have access to a 3d printer?

 

[krayzie]

Think I found the issue my water level was a bit low and wasn’t reaching the first two sensors. Raised it a bit so it should work now!

nice. i didnt really have to increase my height but i guess it depends on each tank

do you have any photos of your setup or will you do a YT vid?

 

[LaReef88]

do you have access to a 3d printer?

no

 

[what_the_reef]

nice. i didnt really have to increase my height but i guess it depends on each tank

do you have any photos of your setup or will you do a YT vid?

Yes! Posted a short

 

[eliasher]

Hi, I have a Waterbox 20 and I recently bought RS Nanomat to be used with one of the 3D printed models shown in the forum but water level is too low. Does anyone have any 3D design working for waterbox 20? Thanks!

 

[Reefer911]

@krayzie
I need help finding a NanoMat adapter for my WB 35.2

Filter sock compartment dimensions are 3.2”x4.7” or 81mm x 120mm

I still have the tabs in place.

 

[krayzie]

@krayzie
I need help finding a NanoMat adapter for my WB 35.2

Filter sock compartment dimensions are 3.2”x4.7” or 81mm x 120mm

I still have the tabs in place.

do you have access to a 3d printer?

 

[krayzie]

Hi, I have a Waterbox 20 and I recently bought RS Nanomat to be used with one of the 3D printed models shown in the forum but water level is too low. Does anyone have any 3D design working for waterbox 20? Thanks!

yes

 

[Reefer911]

do you have access to a 3d printer?

Not that I’m aware of. Seems like everyone has one these days

 

[Reefer911]

@krayzie looks like the UPS store offers 3d printing service