I have done 1 other plumbing project before this that was much smaller. This build has a manifold for a UV sterilizer and it has complicated things.. lol
The union on the left is off about 2/16" so I need to fix it but I messed up once and I am afraid to mess it up again.. x(
I plan to cut the return line at the top before the 90° to the bulkhead. Insert a coupling and remove the N(3/32") + 2/16". This is a 3/4" coupling.
I think it should line up perfectly after that. Any advice is greatly appreciated though!
The union on the left is off about 2/16" so I need to fix it but I messed up once and I am afraid to mess it up again.. x(
I plan to cut the return line at the top before the 90° to the bulkhead. Insert a coupling and remove the N(3/32") + 2/16". This is a 3/4" coupling.
I think it should line up perfectly after that. Any advice is greatly appreciated though!
Last edited: