Zakary2003
Active Member
Hey everyone. I've had my waterbox cube 20 for about a month now and I've gotten some new equipment, including an ATO from fzone and an automatic filter fleece roller from Reef Rolls. However, these two pieces of equipment do not seem to be interacting well. The fleece roller uses a water level sensor to detect when water levels get too high in chamber 1 from the fleece clogging and then turns the motor to replace it with clean fleece, which lowers the levels in chamber 1 again and raises the water levels in 2 and 3. However, as chamber 1 fills, chamber 3 gets lower and causes the ATO to activate despite not needing to, which raises the overall water level and causes the filter roller to go nuts until it finally has an error code after wasting multiple feet of fleece. This results in me going through filter rolls way quicker than I should be, and has also resulted in small salinity swings and overfilling the tank a little until the failsafe kicks in. Is there any way to rearrange my setup so that the two both work properly? I have a top down picture to show what the setup currently looks like but it's hard to understand the issue. I'd be willing to remove the ATO, but there are a few times a year when I have to leave for around 2 weeks at a time and my pet sitter is only comfortable feeding the fish, not topping off or changing the fleece.
