few drops of water in a 7096 controler...

[walkerbrody]

I had a few drops of water run down the pump control cable and apparently into my controller. I opened it up, blew out the controller with my air compressor and cleaned everything. The controller worked fine for a couple hours, but now will not light up and wont connect to my computer through the usb cable. What are the odds it can be repaired?

 

[revsgirl]

:bump2:

 

[Craig Borowski]

Sorry I missed you here! But I think from your other post that you were able to resolve the problem.

 

[fraggingfish]

What you can do was place it in a container of rice, so all of the moisture is gone.

Not sure about now, but you can try to leave it in the container of rice for a day or 2, to confirm moisture has complete evaporated.

It'll only short circuit if there's residue or water that remains on the circuit board.