I built a screen cover for my rimless tank using aluminum window frame, BRS netting and 3D printed corners. I (stupidly) trimmed the mesh before test fitting and discovered that I pulled the screen a little too tight so one side is pulled in.
Any ideas on stretching the mesh?
I was thinking a heat gun and putting under pressure for a while. Any thoughts? Will it stretch? Melt? Do nothing? I need to dig up the heat gun, but I am open to other ideas that dont require new mesh.
Any ideas on stretching the mesh?
I was thinking a heat gun and putting under pressure for a while. Any thoughts? Will it stretch? Melt? Do nothing? I need to dig up the heat gun, but I am open to other ideas that dont require new mesh.