Dosing containers
- Thread starter jdpeters
- Start date
- Tagged users None
PhreeByrd
Active Member
I'm like don_chuwish, but I use the half-gallon ESV bottles due to space limitations. Drill the caps, insert a length of rigid airline tubing to reach the bottom of the bottle, and connect the pump tubing to the rigid tubing. Done.
Makers Marc
Well-Known Member
- Joined
- Oct 15, 2017
- Messages
- 667
- Reaction score
- 300
Will this corrode or leach into a reef tank, if it sits inside my sump as a skimmer drain container?
I use canning jars. They are very inexpensive. Cut a piece of plastic the same size as the typical lid that goes on the jar. Silicone that to the ring so you get a tight seal. Cut a hole in the lid for two pieces of airline tubing. One should be about 3 inches, this will be used to start your siphon. The other goes from about an inch off the bottom of the inside( don’t want to grab any sediment) of the jar to hold below the level of the jar on the outside. (Think just how your aquarium siphon works) put a irrigation style adjustable dripper on the outside end of the siphon.
Put whatever you want to dose in the jar close your lid tight. Blow on the short piece of tubing, watch the water go out the other tubing and your siphon is started.
A quick gravity feed dosing jar with stuff you probably have laying around the house.
Put whatever you want to dose in the jar close your lid tight. Blow on the short piece of tubing, watch the water go out the other tubing and your siphon is started.
A quick gravity feed dosing jar with stuff you probably have laying around the house.
U
User1
Guest
You can but many would see it as a possible source of trouble or a possible point of failure. When I was running a 29 gallon bio cube and dosing kalk I used an older container and attached a IV line to it. This way I could auto top off the water and add kalk at the same time. It seemed to work ok and didn't clog up much al though I do not recall my dose being strong. I've seen some do similar but without the IV line and run to a pair of float valves, etc.
You can, and people do, just need to be aware of any possible faults in the system and design safety in before attempting.
voss water bottles are popular. so much so, i’ve created this cool holder with a handle. it will come with 1/4” bulkheads and internal tubing.
Scrubber_steve
2500 Club Member
Toomnymods
Active Member
voss water bottles are popular. so much so, i’ve created this cool holder with a handle. it will come with 1/4” bulkheads and internal tubing.
wow that's really nice! I love the sleek look of the voss water bottles but I'm worried they would simply get bumped around and fall over under my stand. I'd like to buy 2 of these stand.. where did you get these from?
LBCobra
Community Member
very nice will save your site for when im ready to dose.
Soulreefer
Community Member
For small quantity.
Soulreefer
Community Member
Jonreefer
Valuable Member
i use these for my BRS alk and calcium
https://www.target.com/p/4-w-x-4-d-...age-container-made-by-design-153/-/A-52380506
https://www.target.com/p/4-w-x-4-d-...age-container-made-by-design-153/-/A-52380506
Hey do you still sell this and do you have one that holds 4?
voss water bottles are popular. so much so, i’ve created this cool holder with a handle. it will come with 1/4” bulkheads and internal tubing.
Crabby48
7500 Club Member
Here is his website https://octoaquatics.com/
He no longer is around r2r but can make almost anything you want
Similar threads
New Posts
-
-
ATS screen size formula, has it changed in the last few years?- Latest: Vivid Creative Aquatics
