I am looking for advice for setting up my plank auto feeder. I am leaving the circulating pump in the feeder running all the time, so I only need to setup a timer for the auger(device that delivers food to the aquarium).
What I am trying to accomplish is turning on a switch channel for 30 seconds every 30 minutes between the hours of 9AM to 9PM.
I tried to go into the processes and assign the switch channel to a timer and I was going to manually add the times but I noticed GHL limits the maximum set points to 8.
I am also doing this on my phone or through the myGHL website. I will try later on the GCC on my computer.
Anybody have any ideas on how to set this up?
What I am trying to accomplish is turning on a switch channel for 30 seconds every 30 minutes between the hours of 9AM to 9PM.
I tried to go into the processes and assign the switch channel to a timer and I was going to manually add the times but I noticed GHL limits the maximum set points to 8.
I am also doing this on my phone or through the myGHL website. I will try later on the GCC on my computer.
Anybody have any ideas on how to set this up?