Ammonia in Copper power

[Mr Phu]

The bacteria can take a few days to become activated. Or, the ammonia is building up faster than that amount of bacteria can assimilate.

Sir i have 2 question :
for Hanna checker ( TAN ) what rate for Ammonia is safety for fish ? I read that less 0.20 should be fine is that right ??
Now my new tank seeded for 7 week and Today Hanna Checked 0.08 . So is that complete the cycle ? I just want to make sure before put the fish

 

[Jay Hemdal]

Sir i have 2 question :
for Hanna checker ( TAN ) what rate for Ammonia is safety for fish ? I read that less 0.20 should be fine is that right ??
Now my new tank seeded for 7 week and Today Hanna Checked 0.08 . So is that complete the cycle ? I just want to make sure before put the fish

That’s complicated: the toxicity of ammonia is dependent on the pH of the water. I generally say that at a pH of 8 or lower, ammonia at 0.20 is o.k. If the pH is higher, say 8.3, it is potentially more toxic.
If the ammonia has risen in a tank and then falls to 0.08, that indicates some level of cycling has taken place. However, the question then is; was there a constant source of ammonia for the bacteria to work on? If not, you may only have enough bacterial growing to consume a small amount of ammonia.

 

[Mr Phu]

That’s complicated: the toxicity of ammonia is dependent on the pH of the water. I generally say that at a pH of 8 or lower, ammonia at 0.20 is o.k. If the pH is higher, say 8.3, it is potentially more toxic.
If the ammonia has risen in a tank and then falls to 0.08, that indicates some level of cycling has taken place. However, the question then is; was there a constant source of ammonia for the bacteria to work on? If not, you may only have enough bacterial growing to consume a small amount of ammonia.

Yes i put the fish foods everyday even though without no fish in there
Is that oke ??

 

[Jay Hemdal]

Yes i put the fish foods everyday even though without no fish in there
Is that oke ??

Perfect!

 

[Mr Phu]

That’s complicated: the toxicity of ammonia is dependent on the pH of the water. I generally say that at a pH of 8 or lower, ammonia at 0.20 is o.k. If the pH is higher, say 8.3, it is potentially more toxic.
If the ammonia has risen in a tank and then falls to 0.08, that indicates some level of cycling has taken place. However, the question then is; was there a constant source of ammonia for the bacteria to work on? If not, you may only have enough bacterial growing to consume a small amount of ammonia.

So this case u mean completed cycle ???

Sir i have 2 question :
for Hanna checker ( TAN ) what rate for Ammonia is safety for fish ? I read that less 0.20 should be fine is that right ??
Now my new tank seeded for 7 week and Today Hanna Checked 0.08 . So is that complete the cycle ? I just want to make sure before put fish in there

So this case u mean completed cycle ???

 

[Jay Hemdal]

So this case u mean completed cycle ???

So this case u mean completed cycle ???

That’s what I call “nominally cycled” - meaning that there is enough beneficial bacteria to consume the ammonia load at that time. If you greatly increase the bioload, there will be some lag time as the bacteria needs to reproduce to meet this new load. That’s why the ghost feeding you were doing is helpful.

 

[Mr Phu]

That’s what I call “nominally cycled” - meaning that there is enough beneficial bacteria to consume the ammonia load at that time. If you greatly increase the bioload, there will be some lag time as the bacteria needs to reproduce to meet this new load. That’s why the ghost feeding you were doing is helpful.

Thank Sir !!
Today i see No3 appear after checking . So can i get cycle instant when i putting 3 liter of matrix from 3 year tank ?
So how can i know overload ? I qt 4 anthias on 120 liter tank with 3 liter seachem matrix from 3 year old tank is that enough Sir ?

 

[Jay Hemdal]

Thank Sir !!
Today i see No3 appear after checking . So can i get cycle instant when i putting 3 liter of matrix from 3 year tank ?
So how can i know overload ? I qt 4 anthias on 120 liter tank with 3 liter seachem matrix from 3 year old tank is that enough Sir ?

3 liters of matrix from an old tank should be more than enough to handle the bioload from 4 anthias. Since we cannot see the bacteria, all we can do is make a guess. Then, use your ammonia test to confirm the bacteria is doing its work.

 

[Mr Phu]

3 liters of matrix from an old tank should be more than enough to handle the bioload from 4 anthias. Since we cannot see the bacteria, all we can do is make a guess. Then, use your ammonia test to confirm the bacteria is doing its work.l

i have test Ammonia Hanna checker 3 time for 2 day is around 0.17 to 0.18 ( My PH 7.9 , Temp 24 C )
I feed 4 anthias 1 time day . So is that old bacterial from matrix working ??? Should i dose more bacterial bottle ?

 

[Jay Hemdal]

i have test Ammonia Hanna checker 3 time for 2 day is around 0.17 to 0.18 ( My PH 7.9 , Temp 24 C )
I feed 4 anthias 1 time day . So is that old bacterial from matrix working ??? Should i dose more bacterial bottle ?

I would feed the anthias 3 or 4 times a day, but less food each time (you do not want uneaten food to sit in the tank).

I think that residual amount of ammonia is o.k.

Are you testing for copper? I worry because I see rock in the video and that rock can absorb some copper from the water. You may need to retest for copper, and then add a partial dose to keep it at 2.25 ppm

 

[PotatoPig]

Nevermind, I see Jay covered it.

 

[Mr Phu]

I would feed the anthias 3 or 4 times a day, but less food each time (you do not want uneaten food to sit in the tank).

I think that residual amount of ammonia is o.k.

Are you testing for copper? I worry because I see rock in the video and that rock can absorb some copper from the water. You may need to retest for copper, and then add a partial dose to keep it at 2.25 ppm

No i still not use Copper, they just arrvied 4 day ago . And the shop keep it for a long time , so i still no have a plan for using copper . They are Pictilis anthias very easy to get Uronema . I have a plan to feed them with Metro soaked food , but now they still not eating , but more active than the first day

 

[Jay Hemdal]

No i still not use Copper, they just arrvied 4 day ago . And the shop keep it for a long time , so i still no have a plan for using copper . They are Pictilis anthias very easy to get Uronema . I have a plan to feed them with Metro soaked food , but now they still not eating , but more active than the first day

Metronidazole is very bitter. You need to try and dose it at 1% weight in the food. Soaking is not a good method because it will rinse right off. Mixing with Focus or gelatin is a more secure way of dosing it.

 

[Mr Phu]

Metronidazole is very bitter. You need to try and dose it at 1% weight in the food. Soaking is not a good method because it will rinse right off. Mixing with Focus or gelatin is a more secure way of dosing it.

Thanks Sir !!
I use 1 spoon on picture below Metro Plex to soaked with 1 spoon Focus is that oke ?

 

[Jay Hemdal]

Thanks Sir !!
I use 1 spoon on picture below Metro Plex to soaked with 1 spoon Focus is that oke ?

A one to one ratio with metro and focus is fine, but you then need to add that one part metro to 99 parts food. You will need an accurate gram scale to do that.

 

[Mr Phu]

I usually mixed one to one metro and focus with 3 teaspoon of food . Is that okey ???

 

[Jay Hemdal]

I usually mixed one to one metro and focus with 3 teaspoon of food . Is that okey ???

Sorry, it could be, but you must weigh this out, you cannot just guess at the amount.

 

[Mr Phu]

Sorry, it could be, but you must weigh this out, you cannot just guess at the amount.

Plz Help me this case i Have a Pistilic anthias . now they have a white spot on the mouth . Could u help me identify this ? Is that normal or Mouth rot ??
I search on Google the picture they also have a spot on the mouth like this . I just want to make sure before using treatment

 

[Jay Hemdal]

Plz Help me this case i Have a Pistilic anthias . now they have a white spot on the mouth . Could u help me identify this ? Is that normal or Mouth rot ??
I search on Google the picture they also have a spot on the mouth like this . I just want to make sure before using treatment

Whenever I see a bump on the lower jaw of a fish, I immediately suspect that it is a "rub mark" from running into hard objects in the aquarium.

 

[Mr Phu]

Whenever I see a bump on the lower jaw of a fish, I immediately suspect that it is a "rub mark" from running into hard objects in the aquarium.

So what should i do now ?
Not using any Med just watching right ?
pictilis should be keep 1 male in group , but now i have 2 male in there . I afraid it damged by fighting