OP
OP
What did you order Scott? What’s your pressure like out of the tap?
RO Buddy Help
- Thread starter FindinNemo
- Start date
- Tagged users None
ScottJ
Valuable Member
I ordered the smart booster aquatic life pump. I don't know my pressure, but it's not 80!
- Joined
- Jul 16, 2009
- Messages
- 5,542
- Reaction score
- 9,295
You really need a pressure gauge to tell, but in general you can't go wrong with a booster pump.
Schulks
Well-Known Member
Does everyone run their pressure at 80 lbs exactly?
I was running about 90 because I was told it is risky to mess with the pressure adjustment screws. I broke 2 flush valves over a year and decided to just adjust it. No problems since.
I was running about 90 because I was told it is risky to mess with the pressure adjustment screws. I broke 2 flush valves over a year and decided to just adjust it. No problems since.
- Joined
- Dec 8, 2017
- Messages
- 3,509
- Reaction score
- 7,567
I shoot for 80 psi, which I get without a booster. 90 psi I believe is right on the edge of the maximum recommended. At 100 psi I would expect fittings to be blowing out for sure, from what I've read.
OP
OP
So I purchased a gauge and put it inbetween the sink and supply line and I’m getting around 75 PSI going to the RO buddie. I took another video of my filtered return hopefully this one works, still poor flow for my clean return
So I purchased a gauge and put it inbetween the sink and supply line and I’m getting around 75 PSI going to the RO buddie. I took another video of my filtered return hopefully this one works, still poor flow for my clean return
I believe your pressure gage goes after your pre filters and right before your membrane as the carbon and sediment filters will take a toll on the pressure
OP
OP
Inbetween carbon cartridge and membrane?
So sediment > carbon > pressure gage > membrane > di
OP
OP
22.6 deg Celsius and I have my TDS in the mail currently not sure as of now
OP
OP
I’m on city water as well not a well
OP
OP
I’ll try this now
OP
OP
So I’m getting 77 psi between the carbon and membrane
OP
OP
77 all around, could I have a bad membrane??
OP
OP
So it looks like the deion has a air bubble, I took off all the 1/4 hoses and reattached all the fittings and when I first started up I had steady flow out of the filtered water, I watched air bubbles in the de ion filter and now back to slower flow after about 30 seconds
The waste water to good water ratio is supposed to be about 3:1 or 4:1, is that what you are getting?
OP
OP
So I think I found the problem, I decided to dunk the whole system under water to look for leaks and sure enough the 90 deg elbow ontop of the membrane was blowing bubbles out of it. I re-sealed it and stopped the bubbles and have better flow. According to chat gpt lol, the system should fill up a half a cup in one minute, it’s now producing half a cup in a minute and a half, a lot better than the starting 4 minutes to fill. Due to not being at the optimal pressure, I’ll take it where it currently is now. Thank you for the help and suggestions everyone much appreciated!
Similar threads
