melypr1985
totally addicted
View BadgesExcellence Award
Expert Contributor
Article Contributor
Moderator Emeritus
TODAY IS DEMO DAY!!
(this will take a few posts since I'm doing this right now and only posting during breaks)
Step One: Finish the stand and get it painted/sealed.
We added some support on the bottom there so we can put plywood down on the bottom and on the top.
We went ahead and notched the 2x4's so the plumbing would fit, then cut and screwed down the plywood "decking"
We painted part of it, but once that is dry we will bring the whole thing back inside so we can put the tank and foam board on it and mark the walls where we will cut. The stand will go back outside for the rest of the paint and while that dries we will start cutting out the wall. This particular part wasn't very well thought out on our part, but we are kinda learning as we go.
(this will take a few posts since I'm doing this right now and only posting during breaks)
Step One: Finish the stand and get it painted/sealed.
We added some support on the bottom there so we can put plywood down on the bottom and on the top.
We went ahead and notched the 2x4's so the plumbing would fit, then cut and screwed down the plywood "decking"
We painted part of it, but once that is dry we will bring the whole thing back inside so we can put the tank and foam board on it and mark the walls where we will cut. The stand will go back outside for the rest of the paint and while that dries we will start cutting out the wall. This particular part wasn't very well thought out on our part, but we are kinda learning as we go.